Find more on industrial components from latest blogs

The installation of the host
1. The heat pump host installation is the same with air conditioner outdoor unit installation requirements. It can be installed in the exterior walls, roof, balcony and on the ground. The outlet should avoid the upwind direction.
2. The distance between the host and the storage tank shall not be greater than 5 meters, the standard is 3 m.
3. The distance between the host and the surrounding walls or other obstructions cannot be too small.
4. If stalling the canopy to protect the split heat pump from wind and sun, you should be aware to guarantee the host heat exchanger endothermic and radiation not be hindered.
5. Host should be installed in place with a solid foundation, and ensure upright installation, and fix with anchor bolts.
6. The control panel should not be installed in the bathroom, so as not to affect the normal work

The installation of the holding tank
1. Storage tanks can be installed with the mini split heat pump outdoor unit in outdoor, such as the balcony, roof, ground, and can also be installed in the room. Storage tanks must sit ground mount, the installation should have solid foundation, must withstand the weight of 500kg, cannot be hung on the wall
2. Equipped with a valve near the water storage tank, and water pipes and hot water pipes interface. Note: the outlet of the storage tank must be connected to the PPR pipe over 1.5 meters

Water connections
1. Connect the water interface with water storage tank by the PP-R pipe according to the diagram, and seal with the PTFE TAPE. 2. Connect one end of the check valve with the water pipe, and connect the other end to the holding tank inlet
3. Fill with water: Open the tap water inlet valve, open the faucet in the hot water pipes. Injecting water, until the water overflows, turn off the faucet. Storage leak detection, make ensure watertight.
Note: For the first time use, make ensure that water storage tanks have been filled before plug the power.

Heating pipe connection
1. Drill a Ф70 pipe hole in the wall between the water storage tank and heat pump host, the hole should be slightly tilted to the outside. Wrap a certain length of the cable with plastic ties, both sides put wall pipe jacket through the lay the pipe hole.
2. Removing the head cap on the tank thickness connecting tube, respectively screw the thickness connecting pipe into the connector on the water storage tank connecting pipe, firmly tighten with a wrench.
3. Screw host high-pressure valve and the head cap of low pressure valve connection nozzle, screw the other end of the thickness connection tube into the water tank working fluid inlet, working fluid inlet connection tube pipe mouth, tighten securely with wrench (Note: crude pipe connects to the three-way valve and joints on the tank). Note: Try not to bend the copper pipe, even if distort do not make copper tube fold flat or fracture

www.phnix-e.com is an international enterprise that commits itself to heat pump technology, fixes energy saving and environmental protecting as its development orientation. We can provide various solutions for energy saving such as house heating, sanitary and commercial hot water supplying, swimming pool thermostatic dehumifying and central air-conditioning integrated energy saving. 

The article is come from:http://pannel.aluminum-machine.com/split-heat-pump/household-split-air-source-heat-pump-water-heater-installation-method.htm

More about my article, you also can read:http://industrialaterials.blog.fc2.com